Adaptors, Sensors & Power Packs

Mitsubishi Electric`s advanced interface technologies, room sensors and power options allow you flexibility to tailor your heating and cooling solutions.


Illustration

Input/Output AdapterPAC-YG10HA-EInput/Output Adapter. Provides control for fresh air fan start-up and emergency fire stop. Connects to a centralised and web controller.

Illustration

Pulse Input Control modulePAC-YG60MCA-JPulse Input Control module. Provides an analogue input for: watt hour meter with pulse transmitter, etc. Connects to a Centralised and Web Central Controller.

Illustration

Analogue Input Control modulePAC-YG63MCA-JAnalogue Input Control module. Provides an analogue input for: temperature & humidity sensors, etc. Connects to a Centralised and Web Central Controller.

Illustration

Digital Input and Output Control ModulePAC-YG66DCA-JThe PAC-YG66MCA interface is a digital input and output control module, it provides On/Off control and Fault monitoring via volt free contacts (VFC), the interface allows control and monitoring of two third party items such as fans & lighting and can extend to six items with the use of the PAC-YG10HA-A Adaptor.

Illustration

Interface UnitPAC-SF81MA-EInterface to enable P-Series units to be operated by a Central or Schedule Controller. When the P-Series indoor is connected to a SUZ outdoor use a MAC-399IF-E .The interface is installed on each outdoor unit for: PUHZ-RP71/100/125/140/200/250 and wired to a Central or Schedule Controller

Illustration

Power PackPAC-SC51KUA-JPAC-SC51KUA-J Power Pack. This unit supplies DC power to controller (AG-150A).

Illustration

Remote Operation AdapterPAC-SF40RM-ERemote Operation Adapter. Plugs into the Indoor PCB (PEA-RP, PLA-RP, PCA-RP, PKA-RP). Provides a Non Voltage A-contact for External Input On/Off Control, Emergency Output for Faults, Run Output for Operation.

Illustration

3-Pin Timer AdapterPAC-SE55RA-E3-Pin Timer Adapter. Plugs into the Indoor Unit PCB. Provides On/Off Input; Low Voltage Pulse or Level Contact Start and Stop signal to each indoor unit. For connection to an External Building Time Clock* etc. (*Supplied by Electrician)

Illustration

Interface UnitMAC-333IF-EMA, M-NET and Contact Terminal Interface. Has remote on/off, prohibit/permit control and run/error outputs - all outputs require an independent external 12VDC power supply. Used to connect PAR-21 / PAR-31 to; MSZ-GE/FB/EF, MFZ-KA/FB & SLZ-KA~VAL indoor units or a Central / Schedule Controller to each indoor unit connected to a M or S-Series outdoor unit.

Illustration

Wi-Fi InterfaceMAC-568IF-EThe award-winning MAC-568IF-E Wi-Fi Interface connects discreetly to your heat pump’s control board and should only be installed by an authorised installer. The MAC-568IF-E Wi-Fi Interface is available on Mitsubishi Electric High Wall, Floor Mounted, and Ducted Heat Pumps, and can either be purchased as an optional upgrade at time of purchase, or retrofitted to an existing Mitsubishi Electric model.

Illustration

Ask the Experts: 09 407 6468 

HIKO is supplied in Kerikeri by Gibson Electrical. We service Kerikeri and surrounding areas. We offer no-obligation quotes to help you select the best possible heat pump system for your home. Every home is different, so it’s always wise to ask the experts for help in choosing the right heat pump to meet your needs!

Thank you!

We will contact you shortly

Can't send form.

Please try again later.